1967 Cadillac EldoradoGERALD´S CADILLACS - NEWS

Fixing the 1978 Cadillac Eldorado´s ATC programmer. The AC works again.

****UPDATE****


An update to the article below can be found here as I had to repair the programmer again in May 2015:


The air-condition in my 1978 Biarritz did not work correctly. For some reason the system always stayed in full AC mode and no matter to where I put the temperature dial on the control head I could not get the heat on, no matter what I tried.
The shop manual is very helpful in trouble shooting the system. Its covered in the 1977 factory shop manual (FSM) as there were no changes made to the system in 1978.
It took me a while to fully understand how the system works - so I had to read the FSM multiple times to get the grip what is going on in the system.

First I inspected all the vacuum lines in the car to make sure that there was no leak anywhere, as the heating mode requires a very high vacuum at the vacuum motor in the controller.
All lines were in very good condition. I also checked the control head connections in the dash which were good as well.
I then suspected the vacuum motor in the programmer as it did not move. I removed the programmer from the car. You can access it from underneath the dash on the passenger side or even better if you remove the glove box lining through the glove box.
From there you only have to unscrew 5 screws, unplug the wires and the vacuum lines to get it out.

When I had it out of the car I checked the vacuum motor. I just sucked air through the hose and it moved and held vacuum perfectly.
The transducer or the amplifier in the programmer were most likely the problem.
When I checked the transducer which regulates the vacuum supply to the vacuum motor, I noticed that it seemed to not be connected to the electrical board as it should. I pressed it in, so that it made good contact with the board again and put the programmer back into the car and connected everything again.

***UPDATE 2015 - its not connected with pins but soldered to the circuit board - 3 of this soldering points were broken - the “repair“ I made here only temporarily worked. You have to check the soldering points for a permanent fix***

I started the car and the AC came back to life again immediately. I could see how the vacuum motor went through all the modes as it should according to the position of the temperature dial on the control head.
The build quality of the programmer obviously is not very good and the transducer somehow came loose causing the ATC to not work as it should. ***Update 2015 - it did no come loose but the soldering points broke***
After I tested everything I put the parts back together and can now enjoy a full working ATC in my 78 Biarritz again ;-)


edge
The programmer as seen through the glove box with the connectors and the plastic case removed

edge
The 1977 / 1978 Eldorado MK II Automatic Temperature Control Programmer

edge
The transducer which caused the problem (the golden part with the single vacuum line going into it)

1978AC-Programmer-SM-IMG_4712
The transducer is connected to the electrical board through a couple of pins - it was not connected properly and somehow became loose over the years - that was why the system did not work.
***UPDATE 2015 - its not connected with pins but soldered to the circuit board - 3 of this soldering points were broken***

edge
The vacuum checking relay and the electric connectors.

edge
The vacuum power motor
1978AC-Programmer-Diagram-SM-IMG_0206
from the 1977 FSM

1978AC-Programmer-Diagram-SM-IMG_0205
Trouble shooting guide for when the system works in full AC mode only.

edge
A color coordinated electrical schematic with annotations to describe the various functions of the system.

Comments